Английская Википедия:Arlington Pumping Station

Содержание

Текст

Текст

Текст

Текст

Текст

Текст

Текст

Текст

Текст

The Arlington Pumping Station, built in 1907, is a historic water pumping station on Brattle Court (off Brattle Street) in Arlington, Massachusetts. Its purpose was to provide water to Lexington and higher elevations in Arlington. The station was put in service on December 4, 1907.

Design

The station was designed by CA Dodge & Co, with construction beginning August 23, 1906. It is a brick building Шаблон:Convert long by Шаблон:Convert wide, about Шаблон:Convert from the ground to the cornice. The foundation walls are of Portland cement concrete, faced, where exposed on the outside below the water-table course, with seam-faced granite. Exterior walls are of dark-red faced brick, with Longmeadow brownstone trimmings, and are surmounted by a hip roof supported by steel trusses and covered with slate. The steps at the main entrance, the water-table course and the trimmings below the water-table are of pink Milford granite.

The building is subdivided by a division wall forming an engine room Шаблон:Convert long by Шаблон:Convert wide and Шаблон:Convert high, and a boiler room Шаблон:Convert long by Шаблон:Convert wide and Шаблон:Convert high. The interior facing of the engine and boiler room walls is of red brick. The engine room floor is of red quarry tile. The floors in the basement of the engine room and in the boiler and coal houses are granolithic. In the rear of the boiler room there is an underground coal pocket Шаблон:Convert long by Шаблон:Convert wide by Шаблон:Convert high, covered by a reinforced concrete roof over which the side track is carried. In this roof there are 16 openings through which coal may be unloaded from the cars. The brick chimney is in the rear of the building. It is Шаблон:Convert high and Шаблон:Convert in diameter at the base, diminishing to Шаблон:Convert in diameter at a point Шаблон:Convert below the top. The flue is 2 feet 6 inches in diameter. The main entrance is on the front of the building. The vestibule is Шаблон:Convert by Шаблон:Convert, and on either side of it are the office and toilet room, both Шаблон:Convert by Шаблон:Convert, the three forming a projection from the main building Шаблон:Convert by Шаблон:Convert.

Pumping equipment

The Allis-Chalmers Company furnished the pumping equipment, which was a horizontal, cross-compound, flywheel engine fitted with Corliss valve gear, and operating two horizontal, outside packed, plunger pumps. The high and low pressure steam pistons were 14 inches and 28 inches in diameter, respectively, and the pump plungers 8% inches in diameter, all having a stroke of 18 inches. The capacity of the engine at 65 revolutions per minute was 1,500,000 gallons in twenty-four hours. The engine which was erected by the Blake & Knowles Steam Pump Works was of the horizontal, cross-compound, direct-acting type, operating two outside packed, plunger pumps. The steam cylinders were 11 inches and 22 inches in diameter, the pump plungers 12 inches in diameter, and both pistons and plungers have a stroke of 18 inches. When operated at the rate of 31 revolutions per minute the capacity was 1,500,000 gallons per day. There were two boilers of the horizontal, under-fired type, each 54 inches in diameter, containing 60 3-inch tubes Шаблон:Convert long. The furnaces were fitted with Foster shaking grates, Шаблон:Convert wide by Шаблон:Convert long.

See also

• Mystic Water Works, a pumping station in Somerville
• National Register of Historic Places listings in Arlington, Massachusetts

References

• Massachusetts Metropolitan Water and Sewerage Board, Seventh Annual Report of the Metropolitan Water and Sewerage Board, For the Year 1907, Volume 2, Boston, 1908, pages 97–99.