The L.66 was intended to be a low cost, easy maintenance two-seater. Thus a low power engine was required and the prototype was fitted with a Шаблон:ConvertHaacke HFM-2flat twin, though other engines could be used. It was a cantileverparasolmonoplane with an aerodynamically thick airfoil section wing, which had a simple, rectangular plan and significant dihedral. The wing was a wooden structure with two spars, the ailerons mounted directly to a rounded groove in the rear spar. It was linked to the upper fuselage by a rather complicated set of struts.[1]
Traditionally, Albatros had constructed fuselages with wood frames, but the L.66 marked a departure, with a welded steel tube longeron and strut framework covered with fabric. The sides were flat and almost airfoil-shaped, with a blunt, rounded nose and taper aft. The nose-mounted engine, driving a two-blade propeller, was raised above the fuselage with a fairing behind it, enclosing the oil tank and with the instrument panel attached to its rear. The fuel tank was in the wing centre section, feeding the engine by gravity. Further aft, pilot and passenger sat side by side in the Шаблон:Convert wide fuselage; tandem controls could be fitted if required. The empennage was simple in shape and action as there were no fixed surfaces, only an all-moving rudder and elevator. Both control surfaces were balanced. The conventional undercarriage was also very simple, with the mainwheels attached to a single axle which passed through the fuselage, sitting the L.66 close to the ground. The tailskid was linked to the rudder for steering on the ground[1]
