Английская Википедия:Autoignition temperature
The autoignition temperature or self-ignition temperature, often called spontaneous ignition temperature or minimum ignition temperature (or shortly ignition temperature) and formerly also known as kindling point, of a substance is the lowest temperature in which it spontaneously ignites in a normal atmosphere without an external source of ignition, such as a flame or spark.[1] This temperature is required to supply the activation energy needed for combustion. The temperature at which a chemical ignites decreases as the pressure is increased.
- Substances which spontaneously ignite in a normal atmosphere at naturally ambient temperatures are termed pyrophoric.
Autoignition temperatures of liquid chemicals are typically measured using a Шаблон:Convert flask placed in a temperature-controlled oven in accordance with the procedure described in ASTM E659.[2]
When measured for plastics, autoignition temperature can be also measured under elevated pressure and at 100% oxygen concentration. The resulting value is used as a predictor of viability for high-oxygen service. The main testing standard for this is ASTM G72.[3]
Autoignition time equation
The time <math>t_\text{ig}</math> it takes for a material to reach its autoignition temperature <math>T_\text{ig}</math> when exposed to a heat flux <math>q</math> is given by the following equation:[4]
- <math>t_\text{ig} = \frac{\pi}{4} k \rho c \left [ \frac{T_\text{ig} - T_0}{q} \right]^2, </math>
where k = thermal conductivity, ρ = density, and c = specific heat capacity of the material of interest, <math>T_0</math> is the initial temperature of the material (or the temperature of the bulk material).
Autoignition temperature of selected substances
Temperatures vary widely in the literature and should only be used as estimates. Factors that may cause variation include partial pressure of oxygen, altitude, humidity, and amount of time required for ignition. Generally the autoignition temperature for hydrocarbon/air mixtures decreases with increasing molecular mass and increasing chain length. The autoignition temperature is also higher for branched-chain hydrocarbons than for straight-chain hydrocarbons.[5]
| Шаблон:Note label On contact with an organic substance, melts otherwise. |
| Шаблон:Note label There are two distinct results in the published literature. Both are separately listed in this table. |
| Шаблон:Note label At 1 atm. The ignition temperature depends on the air pressure. |
| Шаблон:Note labelUnder standard conditions for pressure. |
See also
- Fire point
- Flash point
- Gas burner (for flame temperatures, combustion heat energy values and ignition temperatures)
- Spontaneous combustion
References
Шаблон:Reflist Шаблон:Refbegin Шаблон:Refend
External links
Шаблон:Firelighting Шаблон:Authority control
sv:Självantändning#Självantändningspunkt
- ↑ 1,0 1,1 1,2 1,3 1,4 1,5 1,6 1,7 1,8 1,9 Шаблон:Cite journal
- ↑ E659 – 78 (Reapproved 2000), "Standard Test Method for Autoignition Temperature of Liquid Chemicals", ASTM, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959.
- ↑ S. Grynko, "Material Properties Explained" (2012), Шаблон:ISBN, p. 46.
- ↑ Principles of Fire Behavior. Шаблон:ISBN. 1998.
- ↑ Zabetakis, M. G. (1965), Flammability characteristics of combustible gases and vapours, U.S. Department of Mines, Bulletin 627.
- ↑ Шаблон:Cite web
- ↑ 7,0 7,1 7,2 7,3 7,4 7,5 7,6 Шаблон:Citation
- ↑ 8,0 8,1 8,2 Шаблон:Cite web
- ↑ Шаблон:Cite web
- ↑ Шаблон:Cite web
- ↑ Шаблон:Cite web
- ↑ Шаблон:Cite journal (Reproduced from "Firepoint" magazine)
