Английская Википедия:Breadalbane Hydro-Electric Scheme
Шаблон:Short description Шаблон:Use dmy dates Шаблон:Infobox dam The Breadalbane Hydro-Electric Scheme is a hydroelectric scheme in the Breadalbane area of Perthshire, Scotland. It comprises seven power stations which generate 120MW of power from the dams around Loch Lyon, Loch Earn and Loch Tay.[1]
History
The politician Tom Johnston during his time as Secretary of State for Scotland,Шаблон:Sfn championed the Hydro-electric Development (Scotland) Act 1943, which created the North of Scotland Hydro-Electric Board.Шаблон:Sfn Johnston's vision was for a public body that could build hydro-electric stations throughout the Highlands. Profits made by selling bulk electricity to the Scottish lowlands would be used to fund "the economic development and social improvement of the North of Scotland." Private consumers would be offered a supply of cheap electricity, and their connection to that supply would not reflect the actual cost of its provision in remote and sparsely-populated areas.Шаблон:Sfn
The chairman of the new Board was to be Lord Airlie, who had initially been critical of the 1943 Act because its scope was too limited. The deputy chairman and chief executive was Edward MacColl, an engineer with wide experience of hydro-electric projects and electrical distribution networks.Шаблон:Sfn It soon became clear that MacColl intended to push ahead with the aspirations of the Act at breakneck speeds. He produced a list of 102 potential sites in just three months,Шаблон:Sfn and in June 1944, the first constructional scheme was published, for the large Loch Sloy scheme and two much smaller projects at Nostie Bridge and Morar.Шаблон:Sfn The Breadalbane scheme and Breadalbane Amendments scheme were published as constructional schemes 25 and 25A.Шаблон:Sfn
Construction began in autumn 1951. The first stage was the building of Lawers Dam, at the south-eastern end of Lochan na Lairige. This was a fairly small loch, but its level was raised by Шаблон:Convert, enabling it to store Шаблон:Convert of water. From the dam, a tunnel and pipeline feeds the water to Finlarig power station, located on the shore of Loch Tay at its south-western end. Finlarig contains a single 30 MW Pelton turbine generating set, which is the largest Pelton turbine in Britain.Шаблон:Sfn The dam is Шаблон:Convert long and Шаблон:Convert tall at its highest point.[2]Шаблон:Sfn It is of the massive butress type, for which the dam at Loch Sloy was the prototype.Шаблон:Sfn Water descends a vertical distance of Шаблон:Convert from the dam to the power station, the highest drop of any hydro-electric scheme in Scotland for more than fifty years,[3] until it was exceeded by the Glendoe Hydro Scheme in 2009.[4]
To increase the amount of water available, the headwaters of streams that fed into Loch Tay, the River Lyon and the River Lochay were captured by a series of tunnels and aqueducts, increasing its catchment area to Шаблон:Convert. Additionally, headwaters from two tributaries of the River Lochay are fed directly into the tunnel supplying the power station. The dam has two control towers, on either side of the central spillway. One controls the release of compensation water to the Allt a Moirneas, while the other controls the flow of water into the tunnel to Finlarig power station, which was commissioned in 1955.[2]Шаблон:Sfn
The scheme was expanded by the addition of six further power stations, with those to the west and north west of Finlarig comprising the Killin section and those to the south-east of Finlarig comprising the St Fillans section.Шаблон:Sfn
Killin section
Шаблон:Breadalbane hydro-electric scheme map The Killin section consists of three power stations, Cashlie, Lubreoch and Lochay, with two major dams and a third smaller one. Furthest west, Lubreoch dam was constructed at the eastern end of Loch Lyon by James Miller and Partners. It was Шаблон:Convert long and Шаблон:Convert high from the foundations to the crest. It was of the massive butress type and was completed in 1958. The catchment area was increased by building a network of tunnels and aqueducts to the south of the dam, picking up the headwaters of a number of tributaries of both the River Lochay and the River Dochart. Lubreoch power station is located below the dam, and was commissioned in 1958. It has a gross head of Шаблон:Convert and can generate 4 MW. To the north of the power station is Loch an Daimh, which is dammed at its eastern end by Giorra dam. The structure was built by Edmund Nuttall and is Шаблон:Convert long, with a maximum height of Шаблон:Convert. It is also of the massive butress type, and was completed in 1959. Its catchment has been increased by tunnels and aqueducts to the south and east, picking up tributaries of the River Lyon. A tunnel runs from the dam to Cashlie power station, which discharges into Stronuich Reservoir. It has a gross head of Шаблон:Convert, can generate 11 MW, and was commissioned in 1959.Шаблон:Sfn
Stronuich Reservoir is formed by the Stronuich dam, a long low structure that dams the River Lyon. It stores water from the tailraces of Lubreoch and Cashlie power stations. Compensation water to maintain the flow in the River Lyon passes through a generator set below the dam. An intake gatehouse tower is located at the southern end of the dam, and controls the flow of water to Lochay power station.[5] A long tunnel from the reservoir supplies water to Lochay power station, which discharges into the River Lochay a short distance before it joins the River Dochart and enters Loch Tay. It has a gross head of Шаблон:Convert, can generate 47 MW, and was commissioned in 1958.Шаблон:Sfn
St Fillans section
The St Fillans section consists of another three power stations, Lednock, St Fillans and Dalchonzie, with two major dams, Breaclaich and Lednock. Lochan Breaclaich dam prevents water flowing into the Loch Tay catchment. It is a rockfill dam, with a concrete panels on the upstream side and coursed rubble on the downstream side. A gatehouse controls the inlet to a tunnel and pipeline which feeds Lednock power station.[6] A tunnel collects headwaters from streams flowing into Loch Tay to the south-west of the reservoir, while another tunnel conveys water to Lednock power station.Шаблон:Sfn This contains a single 4 MW turbine, which is protected by a surge tower to the north-west of the station. The water discharges into Loch Lednock.[7] The power station has a gross head of Шаблон:Convert and was commissioned in 1961.Шаблон:Sfn
Loch Lednock is contained by a diamond-headed butress dam at its eastern end. The dam was constructed by Taylor Woodrow, is Шаблон:Convert long and Шаблон:Convert high. It was completed in 1957. The catchment of Loch Lednock is supplemented by a tunnel collecting the headwaters of the River Almond.Шаблон:Sfn There is only one other diamond-headed butress dam in Scotland, at Errochty. Because it is close to the Highland Boundary Fault, it was designed to cope with earthquakes. A dispersal valve discharges compensation water through the dam to maintain the flow in the River Lednock. There is an intake gatehouse around half way along the loch, which controls the flow of water to St Fillans power station.[8] This was the first of the additional power stations to be commissioned when it was completed in 1957. It has a gross head of Шаблон:Convert and can generate 21 MW. The power station is constructed underground, whereas all of the others have buildings on the surface. It discharges into Loch Earn, which in turn supplies the River Earn.Шаблон:Sfn A small weir just below the outlet from the loch diverts some of the flow into a tunnel to provide power for Dalchonzie power station. It contains a single 4 MW turbine,[9] and discharges back into the Earn. Its gross head is Шаблон:Convert and it was commissioned in 1958.Шаблон:Sfn
Development
The North of Scotland Hydro-Electric Board were always looking for ways to improve their processes, and there is evidence of this at Breadalbane. The rock fill dam at Breaclaich was built to reduce the amount of cement used, and this technique had previously been used at Quoich. Fly ash was used to replace some of the cement used in the construction of the dams at Lednock, Lubreoch and Giorra. This causes the concrete to harden more slowly, but is less permeable once it has cured.Шаблон:Sfn Although several of the dams are similar, they are different in detail, as new methods were used to reduce the amount of concrete and shuttering that was required. The massive butress dam proved to be considerably cheaper to build than a solid gravity dam, by about 30 per cent.Шаблон:Sfn
There were advances in tunnelling techniques too. The main tunnels connected the reservoirs to the power stations, but there were also lots of tunnels used to divert water from other catchments. In total, the scheme involved some Шаблон:Convert of tunnels, and the Board worked hard to train tunnellers and improve drilling techniques. The tunnel from Stronuich to Lochay is Шаблон:Convert in diameter, and some Шаблон:Convert long. While a world record was claimed in October 1955 when a collecting tunnel in the St Fillans section advanced by Шаблон:Convert in seven days,Шаблон:Sfn the Lochay tunnellers hit a water-bearing fault which resulted in Шаблон:Convert per hour flowing into the workings, and flooding Шаблон:Convert of the tunnel. The potential disaster was dealt with relatively easily, by pumping out the tunnel and using cast-iron segments to line a diversion. All of the tunnelling on the Killin section was completed nine months ahead of schedule. Most of the scheme was completed by late 1959, with only the Lednock station held up by issues with the Breaclaich section, resulting in it not being commissioned until March 1961.Шаблон:Sfn
References
Bibliography
External links
Шаблон:Stack Шаблон:Commons category-inline
