Английская Википедия:Class A airfield
Шаблон:Use British English Шаблон:Use dmy dates
Class A airfields were World War II military installations constructed to specifications laid down by the British Air Ministry Directorate-General of Works (AMDGW). Intended for use by heavy bombers and transports, they were the standard air base design for the Royal Air Force as well as U.S. Army Air Forces units operating from the UK.
Upon the entry of the US into the war a number of RAF Class A bases were transferred to the U.S. Eighth Air Force for use as heavy bomber bases with the RAF units formerly occupying them being redeployed to other RAF bomber airfields, and U.S. Army Engineer Units constructed more airfields to this standard or brought earlier airfields up to this specification by lengthening runways, etc.Шаблон:Sfn Many units of the U.S. Ninth Air Force also flew from Class A airfields. The term Class 'A' came about because, quite often, the resultant aerial shot of the crossed runways would look like the letter A.Шаблон:Sfn
Design
The specifications set by the British Air Ministry in August 1942 called for three converging strips, each containing a concrete runway optimally placed—if practicable at the site—at 60-degree angles to each other in a triangular pattern.[1] The longest strip was designated the main strip and aligned southwest to northeast wherever possible, this being chosen to allow aircraft to take off and land into the prevailing wind. The other two runways were to allow safe takeoff and landing from either end when the wind was blowing from other directions. The primary consideration was for operational safety for any type of aircraft then in operation or under development.
The runways were connected by taxiways called a perimeter track (peri-track), of a standard width of Шаблон:Convert.Шаблон:Sfn However, certain stations that were designated to be fighter bases sometimes had a narrower perimeter track, such as RAF Coltishall, whose peri-tracks measured Шаблон:Convert across.[2] A Шаблон:Convert area was cleared and leveled on either side of the perimeter track. Class A specifications for taxiways set a minimum curve radius of Шаблон:Convert measured from the centre line for angles greater than 60 degrees and Шаблон:Convert for angles less than 60 degrees. Perimeter track gradients could not exceed 1 in 40 in any direction, and no building could be placed closer than Шаблон:Convert from the edge of the track.
Areas called hardstands were placed along the perimeter track, made of concrete, with their centres at least Шаблон:Convert from the edge of the track and the edges of each hardstand separated from each other and from the funnels by a minimum of Шаблон:Convert. The purpose of the hardstands was to allow aircraft to be dispersed some distance from each other so that an air attack on the airfield would be less likely to destroy all the aircraft at once. Dispersal also minimised the chance of collateral damage to other aircraft should an accident occur whilst bombing-up. Hardstands were either of the Frying-Pan or Spectacle Loop type, with the Spectacle type being the easiest in which to manoeuvre aircraft.Шаблон:Sfn
The strips were Шаблон:Convert in width, cleared, graded and surfaced with turf. A concrete runway Шаблон:Convert in width was centred on the strip, with a length of at least Шаблон:Convert for the main strip and at least Шаблон:Convert for the secondary strips.Шаблон:Sfn On each side of the strip the field was cleared of obstructions and leveled an additional Шаблон:Convert. Gradients for the strips were a maximum 1 in 80 longitudinally and 1 in 60 transversely. In addition, an area at the end of each runway was cleared of obstructions at an angle of fifteen degrees outward from each side on a rising imaginary plane of 1 in 50 to provide a flight way called a funnel.
Construction
The material needs for building runways suitable for heavy bombers were approximately 18,000 tons of dry cement and 90,000 tons of aggregate. Expected stress factors of 2,000 pounds per square inch led to runway thicknesses of six to nine inches of concrete slab laid on a hardcore base, covered with a layer of asphalt. In areas where there was no natural rock, such as East Anglia, stone had to be imported for the hardcore. Up to six trains ran daily from London to east Anglia carrying rubble from destroyed buildings in Luftwaffe raids. This material was used as hardcore for the airfields.Шаблон:Sfn
Operational use
Nine airfields (Alconbury, Bassingbourn, Chelveston, Grafton Underwood, Kimbolton, Molesworth, Podington, Polebrook, and Thurleigh) were allotted to the Eighth Air Force but had been completed prior to the Class A standard for runway lengths. These were brought to Class A standards in 1942 and early 1943 by extending their runways, repositioning their perimeter tracks, and adding additional hardstands.
Class A airfields were also characterized by standardized technical site requirements for repair, maintenance and storage of aircraft. Two T-2 type metal hangars (240 feet long by 115 feet wide by 29 feet high) were the standard for most airfields, although a few pre-1942 bases had three T-2 hangars and Thurleigh had four. Three bases (Chelveston, Molesworth, and Polebrook) also had a J Type brick-and-metal hangar (300' X 151') in addition to a pair of T2's, and Bassingbourn, which had been a pre-war RAF bomber station, had four C type brick hangars measuring 300 by 152 feet
Several airfields had their runways widened and extended in length for emergency landing of damaged bombers after operations over Germany, these airfields, RAF Woodbridge, RAF Carnaby, and RAF Manston being designated as "Emergency Landing Grounds" – ELG's. These ELG airfields had some of the first fitments of the fog-dispersing installation, FIDO.
Post-war motorsport use
With the end of World War II and the resurgence of the sport of motor racing several former airfields were used as race tracks, including Silverstone, Castle Combe, Goodwood and Thruxton.
Most race tracks on former airfields use the encircling perimeter track, although the main straight at Snetterton is laid down on a secondary runway,[3] and the main runway is used at Santa Pod Raceway (formerly RAF Podington) for drag racing.[4]
See also
References
Citations
Bibliography
- Английская Википедия
- Страницы с неработающими файловыми ссылками
- World War II airfields
- World War II strategic bombing
- Aerial warfare strategy
- Royal Air Force stations
- Страницы, где используется шаблон "Навигационная таблица/Телепорт"
- Страницы с телепортом
- Википедия
- Статья из Википедии
- Статья из Английской Википедии
